Doepfer A-160-2 Clock/Trigger Divider II

The Doepfer A-160-2 Clock/Trigger Divider II is a long-awaited updated version of the basic A-160 clock divider module. A nice response to the 4ms clock divider tools: much more fun to use, yet still in the range of affordability.
100,00 € 83,33 €

Verfügbarkeit: Limited stock

Ships Monday, August 20 if ordered in the next 1 day, 19 hours and 25 minutes!

SKU
A-160-2

The Doepfer A-160-2 Clock/Trigger Divider II is a long-awaited updated version of the basic A-160 clock divider module. A nice response to the 4ms clock divider tools: much more fun to use, yet still in the range of affordability.


Module Doepfer A-160-2 Clock/Trigger Divider II is an enhanced version of the standard clock divider A-160. The module is a frequency divider for clock/trigger/gate signals, designed to be a source of lower frequencies, particularly for rhythm uses. The Clock input will take any digital signal from, eg., an LFO, MIDI sync, or the gate from a MIDI-CV interface. At the outputs, you have access to three sets of seven different sub-divided clock signals, from half the clock frequency down to 1/128. The low/high levels of the output signals are 0V and about +10V.

The A-160-2 also has a reset input. Whenever a reset signal is sensed, all outputs are set to certain levels which depend upon the selected mode.

These are the most important features of the module:

  • Three different sets of dividing factors, selected by a three-position switch at the front panel:
  • power of two: 2, 4, 8, 16, 32, 64, 128
  • prime numbers: 2, 3, 5, 7, 11, 13, 17
  • integer: 2, 3, 4, 5, 6, 7, 8
  • Two output modes, selected by a two-position switch at the front panel:
  • Gate mode: outputs act like the outputs of typical binary dividers
  • Trigger mode: in this mode the outputs are AND-wired with the clock signal (i.e. the clock pulsewidth affects the pulsewidth of the outputs)
  • lock edge type selected by a jumper on the pc board:
  • positive: the rising edge of the clock signal triggers the state change of the outputs
  • negative: the falling edge of the clock signal triggers the state change of the outputs
  • Reset behaviour by two jumpers on the pc board:
  • level triggered: the level at the Reset input triggers the Reset
  • edge triggered: the edge of the signal at the Reset input triggers the Reset
  • positive: a high level (> 2.5V) or the rising edge at the Reset input triggers the Reset
  • negative: a low level (< 1 V) or the falling edge at the Reset input triggers the Reset
  • Output polarity selected by a jumper on the pc board:
  • positive: non-inverted outputs
  • negative: all seven outputs are inverted

The sketches show the behaviour of the outputs for the different modes:

Weitere Informationen
Width (HP)4
Depth (mm)20
Skiff friendlyJa
Schreiben Sie eine Bewertung
Sie bewerten:Doepfer A-160-2 Clock/Trigger Divider II