AJH Synth V-Shape (Black)

The V-Shape is two modules in one, a wave twister and a distortion / wavefolding module.
Availability: Out of stock

The V-Shape is two modules in one, a wave twister and a distortion / wavefolding module. 

Both sections of the module are all analogue in design, and both can be used independently or they can be normalised together in series, so that a waveform can be twisted first and then distorted and wavefolded.

The wave twister can take (for example) a saw tooth waveform as an input and shape it, under manual or external voltage control, through to being a triangle waveform and on to being a ramp waveform, and produces a sound similar to pwm for sawtooths. It will also work with symetrical waveforms such as triangle and sine waves, again producing pwm like tones.

It can produce a wave twisting effect from most waveforms (with the exception of square waves), whether they are symmetrical or asymmetric. Under many conditions the transfer function is not perfect, so different harmonics may be generated too. The offset control allows a bias to be added to the incoming waveform, either to bias it correctly around zero or offset it for more distortion and harmonics. 

The second part of the V-Shape module is a distortion unit, with selectable Soft or Hard Clipping, and the clipping amount can be varied either by a front panel control or an external control voltage with the "Distort" control. The distortion offset control adds or subtracts a bias voltage to the CV signal, to give an extended range of control. There is also a single stage, switchable wavefolder, which can be used with either soft or hard clipped waveforms.

Module Width: 10hp

Module Depth: 26mm (Including power lead)

Current Usage: 75mA Positive, 45mA Negative

In Depth

The V Shape twister section functions according to the following mathematical formula: Output = min(In/CV, (Inverted In)/1-CV), where in In is the input voltage and CV is the CV voltage. The output waveform is around 10% to 90% duty cycle, as there is always a slight mixing of the inverse signal. It also relies upon the incoming waveform being exactly 10v peak to peak and biased equally around zero, and if this is not the case then it will do some interesting non linear distortions which, in conjunction with the Offset control, can generate a wider range of sounds.

The distortion section adds distortion without significantly varying the output level, particularly with the Hard clipping function, it maintains the same output level but gradually squares off the top of the waveform, great for creating waveforms suitable for woodwind type sounds, or just for adding a little voltage controlled "nastyness" to an incoming waveform. The wavefolder can be switched in separately and used with either the Soft, or hard clipped waveforms.

Write Your Own Review
You're reviewing:AJH Synth V-Shape (Black)