4ms Pedals - ROW POWER 40

4ms Pedals - ROW POWER 40 is one of the cleanest power supply modules that never overheat and can provide you with enough amps on every rail for even the most power-hungry modules that would have several minor or major issues with other power supply systems. Not to mention that with ROW POWER, your audio processors (filters, VCA's) can also sound a bit better. No mystery here: more stable and clean power, better audio quality!

ROW POWER is a clean, regulated, and protected power solution for eurorack systems.

ROW POWER 30 provides 30W of power, suited for any typical eurorack row ([email protected]/[email protected]/[email protected])

ROW POWER 40 provides 40W of power, suited for up to two typical eurorack rows ([email protected]/[email protected]/[email protected])

Simply plug a laptop style power supply into either of the barrel plugs on the 4HP panel. Connect your modules via flying-bus cables, or connect the ROW POWER to a Distro Board.

Daisy-chain multiple ROW POWERS to use a single power brick for multiple rows. Each row will be independantly regulated and protected for ultra-low cross-talk between rows. Rows can also be hot-swapped (plugged/unplugged without powering the whole system down).

Features

Two power jacks for daisy-chaining multiple ROW POWERS: a common laptop-style power brick could power 3-5 rows (typical)

On/off switch cuts power without interrupting the daisy-chain

ROW POWER 30 provides more than enough power for a 84HP or 104HP row of modules.

ROW POWER 40 is suited for up to 2 typical eurorack rows

Ultra-clean: Each rail is separately regulated with high-grade components

Runs cool: ROW POWER is efficient so it won't heat up your system. Electronics like to chill!

Skiff-friendly: only 27mm (1.1") with power connectors installed.

CV/Gate headers for expansion

Blade tabs for power entry, to be used in custom installations (e.g. if the 4HP panel is not used)

Available in matte black, or white panel (limited time)

Specs:

ROW POWER 30: +12V @ 1.5A, -12V @ 0.75A, +5V @ 0.5A

ROW POWER 40: +12V @ 1.5A, -12V @ 1.25A, +5V @ 1.5A

Powered by laptop-style DC power supply: 2.1mm barrel, positive center, 15V-20V.

A 90W power brick typially powers about 416HP (4 rows of 104HP).

Noise performance figures to be released